Kenwood DPX520BT Instruction Manual page 28

INSTALLATION / CONNECTION
Installing the unit (in-dash mounting)
Do the required wiring.
( 27)
Dashboard of your car
When installing without the mounting sleeve
1
Remove the mounting sleeve from the unit.
2
Align the holes in the unit (on both sides) with the
vehicle mounting bracket and secure the unit with
screws (commercially available).
Use only the specified screws. Using wrong screws might damage
the unit.
26
Bend the appropriate tabs to hold the mounting
sleeve firmly in place.
How to remove the unit
1
Fit the catch pin on the extraction keys into
the holes on both sides of the trim plate,
then pull it out.
2
Insert the extraction keys deeply into the
slots on each side, then follow the arrows as
shown below.
Part list for installation
(A) Mounting sleeve
(B) Wiring harness
(C) Extraction key
(D) Trim plate