Table of Contents
Advertisement
12
Recording Operations
Recording Using a Timer
(Timer Recording)
By connecting a timer (not supplied) to the deck, you
can start and stop recording operations at specified
times. For further information, refer to the instructions
that came with the timer.
1
Dosteps 1 to 7 of "Recording on a DAT" on pages 4
and 5.
2 = «© Tospecify the time for the start of recording, press
a.
* To specify the time for the end of recording, do
steps 8 and 9 of "Recording on a DAT" on pages 4
and 5.
* To specify the time for the start and end of
recording, press Ml.
Set TIMER on the deck to REC.
4
Set the timer as required.
* When you have set the time for the start of
recording, the deck turns off. When the specified
time arrives, the deck turns on and after about 4
seconds starts recording.
¢ When you have set the time for the end of
recording, the deck continues recording, then
when the specified time arrives, the deck stops
recording and turns off.
© When you have set the time for both the start and
end of recording, the deck turns off. When the
starting time arrives, the deck turns on and after
about 4 seconds, recording starts. When the
ending time arrives, the deck stops recording and
turns off.
5
After using the timer, set TIMER on the deck to OFF.
Notes
¢ If TIMER switch is left at the REC position, the deck will
automatically start recording when you turn on the deck
next time.
¢ During Timer Recording (i.e., when the TIMER switch is set
to the REC position), Auto Rewind (see page 13) will not
function even if the tape ends during recording. This is to
prevent previously recorded material from being recorded
over.
Playback Operations
For basic playback operations, see page 6.
ee
ee
|
About the Display
You can use the display to show the following types of
time information:
¢ absolute time
* playing time of the track
¢ remaining time on the tape
* tape running time
MODE RESET
Showing the absolute time, playing time of
the track, remaining time on the tape, and
tape running time.
Press MODE (or COUNTER MODE on the remote).
Each time you press the button, the displayed
information changes as follows.
Absolute time
ans Tae
820.
Press <
Playing time of the track
=
3n15,
Press
<b
Remaining time on the tape
1400.
In the case of premastered DAT, the
remaining time is to the end of the
Tape running time
Press
To reset the tape running time
Press RESET (or COUNTER RESET on the remote).
Advertisement
Table of Contents
