Table of Contents
Advertisement
Linksys USA, Inc.
Regulatory Information
Table of Contents
Wireless Regulatory Information
FCC Statement
FCC Radiation Exposure Statement
Innovation, Science and Economic Development Canada Statement
Innovation, Science and Economic Development Canada Radiation
Exposure Statement
Restrictions in the 5 GHz Band
Additional requirements for the band 5600-5650 MHz
Avis d'Innovation, Sciences et Développement économique Canada
Avis d'Innovation, Sciences et Développement économique Canada
concernant l' e xposition aux radiofréquences
Restrictions dans la bande 5 GHz
Prescriptions supplémentaires pour la bande 5600-5650 MHz
Wireless Disclaimer
Avis de non-responsabilité concernant les appareils sans fil
Safety Notices
Wireless Regulatory Information
FCC Statement
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation
.
This product has been tested and complies with the specifications for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used according to the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which is found by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and devices
• Connect the equipment to an outlet other than the receiver's
• Consult a dealer or an experienced radio/TV technician for assistance
FCC Caution
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this
equipment.
2.4 GHz operation of this product in the USA is firmware-limited to channels
1 through 11. Selection of other channels is not possible.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 35 cm between the radiator and your body.
3
This device and it's antennas(s) must not be co-located or operating
3
in conjunction with any other antenna or transmitter except in accordance
3
with FCC multi-transmitter product procedures.
3
4
Innovation, Science and Economic Development
Canada Statement
4
4
CAN ICES-003(B) / NMB-003(B)
5
5
This device complies with ISED's license-exempt RSS standards.
5
Operation is subject to the following two conditions: (1) This device may
5
not cause interference, and (2) this device must accept any interference,
6
including interference that may cause undesired operation of the device.
6
6
7
For product available in the USA/Canada market, only channel 1~11 can be
operated for 2.4 GHz. Selection of other channels is not possible.
The device could automatically discontinue transmission in case of
absence of information to transmit, or operational failure. Note that this is
not intended to prohibit transmission of control or signaling information or
the use of repetitive codes where required by the technology.
Innovation, Science and Economic Development
Canada Radiation Exposure Statement
This equipment complies with ISED radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed and
operated with minimum distance 35 cm between the radiator & your body.
This device and its antennas(s) must not be co-located or operating in
conjunction with any other antenna or transmitter except in accordance
with ISED multi-transmitter product procedures.
Restrictions in the 5 GHz Band
The device for the band 5150-5250 MHz is only for indoor usage to
reduce potential for harmful interference to co-channel mobile satellite
systems.
This device has been designed to operate with an antenna having a
maximum gain of 4.69 dBi and 5.01 dBi at 2.4 GHz and 5 GHz
respectively. Antenna having a higher gain is strictly prohibited per
regulations of ISED. The required antenna impedance is 50 ohms.
The maximum antenna gain (Please see the table below) permitted
(for devices in the bands 5250-5350 MHz and 5470-5725 MHz) to
comply with the EIRP limit and the maximum antenna gain permitted for
devices in the band 5725-5850 MHz shall be such that the equipment
still complies with the EIRP limits specified for point-to-point and non-
point-to-point operation as appropriate because high power radars are
allocated as primary users (meaning they have priority) in 5250-5350
MHz and 5650-5850 MHz, these radars could cause interference and/
or damage to license exempt LAN devices. The worst-case tilt angle(s)
necessary to remain compliant with the e.i.r.p. elevation mask requirement
set forth in Section 6.2.2(3) shall be clearly indicated.
4
Advertisement
Table of Contents
