ALIGNMENT PROCEDURES
MECHANICAL ADJUSTMENTS
1.
REC/PLAY READ ADJUSTMENT
(1)
Adjust screw (A) so that the chip of the head gauge (M-300) does not touch the tape guide as
shown in figure 2.
(2)
Make the mechanical assembly stand and adjust screw (B) as shown in figure 3.
NOTE:
Never fail to confirm the above adjustment (1) when adjusting screw (B).
(3)
Connect VTVM to line output jacks and play back 10 kHz test tape (TEAC MTT114).
Adjust screw (C) so that the output on the VTVM will be maximum and have a little level
change (less than 1 dB) at both channels.
NOTE:
Never fail to confirm the above adjustments (1) (2) when adjusting screw (C).
(4)
Repeat steps 1 through 3 until being able to confirm above all adjustment without adjustment.
LON
(c) R/P HEAD ()
FIGURE 1
TAPE
GUIDE
90°
CHIP
FIGURE
2
FIGURE 3