Pioneer DC-Z74 Operating Instructions Manual page 7

SPY AKERS,
Plug the power cord into the household electrical outlet only
after all the connections have been completed.
Proceed as follows with the set-up and connections.
1. Place the cassette deck amplifier on top of the CD player.
2, Connect the CD player OUTPUT jacks to the cassette deck am-
plifier CD INPUT jacks with audio cords.
lf using this unit together with the optional CD player PD
Z274T or PD-Z84M, connect the flat cable 7).
3. Place the tuner on top pf the cassette deck amplifier.
4, Connect the tuner input/output cord '5. to cassette deck ampli-
tier.
TUNER AND CD PLAYER CONNECTIONS (Diagram [2])
insert the connector until it locks, thus ensuring that it is con-
nected, When disconnecting the connector, pull it in the oppo
site direction while pressing the left and right claws
BEFORE CONNECTING THE CONNECTION CORD,
SWITCH OFF THE DECK AMPLIFIER, THEN PUSH IN THE
| PLUG OF THE CORD FIRMLY UNTIL IT LOCKED INTO
| PLACE,
5. Connect the FM antenna |: and the AM loop antenna :2 to the
tuner's antenna terminals.
6. Place the turntable on top of the tuner.
7. Connect the turntable connection cords '9 to the CD cassette
deck amplifier's jacks.
If using the turntable PL-Z94, connect the turntable's audio
cords and power supply cord respectively to the CD cassette
deck amplifier's PHONO jacks and DC 12V OUTPUT jack
lf using a different turntable, connect its audio cord and
ground cord in the PHONO jack and the ground terminal,
respectively
8. Use the "LD/VCR" jacks for connection to the audio jacks of
an LD player or VCR.
NOTE
© Insert the plugs securely into the jacks. Improper connection
can lead to sound distortion or malfunction.
¢ The white plug is for the left channel connection and the red
plug for the right channel connection.
* When connecting or disconnecting the input/output cord, do
so only after disconnecting the power plug from the wall
socket
9. Connect the speaker cords 10: to the SPEAKERS terminals.
Connect the "+" terminals on the CD cassette deck amplitier
to the "+" terminais on the speakers, the "--" terminals on
the CD cassette deck amplifier to the "~" terminals on the
speakers
Connecting the speaker cords.
See Fig 3.
1. Cutter 4 Twist the strands.
2: Speaker cord (5) Push away.
33°70 mm 6) Pull back.
NOTE.
Do not allow the conductors of the cords to project out of the
terminals of to come into contact with other conductors. A
breakdown or failure may occur when conductors touch
Speaker impedance
[Multi-voltage model]
Connect speaker systems with a nominal impedance of between
6 and 16 Q.
[Australian model]
Connect speaker systems with a nominal impedance of between
8 and 16 Q.
Surround speaker connection
See Fig 4.
Connect the plugs properly.
Connect a speaker system with a nominal impedance of 16 @ or
more.
10. Connect the CD player's power cord to the deck amplifier's
AC OUTLET.
11. Finally, connect the power cord {2 to the AC wall sacket.
?
<ARB1278>