Mounting The Compressed Air Hose Reel; Commissioning; Connecting The Compressed Air Hose Reel To A Compressed Air Source; Connecting The Compressed Air Hose Reel To A Compressed Air Tool - Parkside PDST 10 B3 Translation Of The Original Instructions

Mounting the compressed air
hose reel
WARNING! RISK OF INJURY!
► Incorrect installation of the compressed air
hose reel can lead to injuries.
■ Make sure that there are no cables or pipes at
the installation site. If necessary, use a detector
or contact a specialist.
■ Also observe the safety instructions for the drill
that is used.
NOTE! RISK OF DAMAGE!
► Incorrect installation can lead to damage.
■ Make sure that the support material (wall) at
the installation location is strong enough to
support the weight of the compressed air hose
reel. If you have any questions, please contact
a specialist.
1. Use the pivoting mounting bracket 2 as a
template. You can disconnect the mounting
bracket 2 from the compressed air hose reel
after you have removed the two screws 8 by
turning them anticlockwise (see fig. B).
Mark the position of the holes on the support
material with a pencil.
2. Drill the holes required for mounting in the
support material.
3. Mount the mounting bracket 2 with suitable
fixing material (see mounting accessories 0 q).
4. Reattach the compressed air hose reel to the
mounting bracket 2.
To do this, screw the screws 8 that you
removed in step 1 back in clockwise (see
Figure B).
PDST 10 B3

Commissioning

Connecting the compressed air hose
reel to a compressed air source
Plug the compressed air connection 7 of the
♦
compressed air hose reel into the quick coupling
of the compressed air source.
Connecting the compressed air hose
reel to a compressed air tool
NOTE! RISK OF DAMAGE!
► Improper handling of the compressed air
hose reel can lead to damage.
■ Never exceed the maximum working pressure
of the compressed air hose reel and ensure that
the connectors used are compatible.
The compressed air hose can be immediately
connected to the compressed air tool via the air
inlet of the compressed air tool using the quick
coupling 6.

Using the compressed air hose reel

WARNING! RISK OF INJURY!
► The compressed air hose reel is equipped
with a return mechanism. This is operated by
a strong spring. If the compressed air hose 5
rolls up incorrectly, injuries may occur.
Never allow the compressed air hose 5 to
■
spring back in an uncontrolled way.
■ If the return mechanism is damaged, stop using
the compressed air hose reel immediately.
Have the damage repaired by a specialist.
■ The compressed air hose reel has a locking and
return mechanism. This makes it easy to pull out
and return the compressed air hose 5.
■ The locking device generates a clicking noise
when rolling up and unrolling. This is not a fault.
If the noise changes after using the equipment
numerous times and/or if there are problems
with the mechanism, seek expert assistance or
contact customer service.
GB │ MT │ 35 ■