Installation Instruction - Atlas Copco LT 2 Instruction Book

Instruction book
Reference
6
7
8
9
10
11
13
14
15
16
19
3.2

Installation instruction

Install the unit in an area where the noise levels do not cause inconvenience and adequate ventilation is
available for cooling purposes.
2920 7089 90
Description
Manual condensate drain
Hole, 15 x 25 (3X)
Receiver
Cooling air inlet
Motor cooling air inlet
Compressed air outlet
Compressor cooling air and air inlet
For dismantling air filter
Compressor air outlet with flexible (2 meters)
Electric cable entry (on rear side)
Air outlet
Before commencing installation, check that the electrical data on the compressor
specification plate/s are compatible with the local power supply. Before connecting, the
electricity, ensure that the power supply is off and correctly isolated.
The electrical power supplied to the compressor unit must be connected by a qualified
electrician in accordance with the wiring diagram supplied with the plant. All wiring must
be in accordance with IEE regulations. Cable sizes given in section. Electric data are
recommendations only.
Installation proposal for tank-mounted unit (90 l receiver)
39