Table of Contents
Advertisement
D auto-changer section
Symptom
Cause
Remedy
CD auto-changer input is not
connected to the unit.
:D auto-changer mode
annot be selected.
'D play does not start.
Power button is not turned ON.
Connect the CD auto-changer input to
the unit.
Turn the power button ON, press the
SOURCE button, and select the CD
auto-changer mode.
he specified disc is not
The specified disc is very dirty.
Check and, if possible, clean the disc.
layed; a different disc is
layed instead.
The disc is loaded upside down.
Eject the disc magazine and insert the
disc correctly.
Two discs are inserted in a slot.
Eject the disc magazine and insert the
discs correctly.
disc is inserted is different from the
number of the specified disc.
The number of the slot into which the
'Eject the disc magazine and check the
number of the specified disc.
The disc is severely damaged
Something is touching the CD auto-
sound skips due to
changer.
ipration.
Use another disc.
Keep it away from the CD auto-changer.
The disc is dirty or damaged.
If sound skips at the same part, the disc
is faulty.
Check and, if possible, clean
the disc.
sound quality is poor.
The recording of the disc is poor.
Try playing another disc. If the sound is
good, the fault was with the origina!
disc.
The disc is dirty or damaged.
Check and, if possible, clean the disc.
Jo sound is heard even
Volume is set to minimum level.
Raise the volume level.
hough the information
oncerning the CD auto-
'hanger is displayed.
The microcomputer does not function
correctly.
Press the Reset button on this unit.
The system is not connected
properly.
The player is set to RANDOM
;
aie
he specitign ecient
PLAY/MAGAZINE RANDOM PLAY
layed,
Connect the system properly.
See
"Connections" (Page 47).
Turn off RANDOM
PLAY/MAGAZINE
RANDOM PLAY.
1 some Cases, you may see one of the following error messages on your unit's
isplay
E-01:
No disc magazine in changer. Disc magazine is not inserted properly
=> Insert the disc magazine properly.
E-02:
= Nodisc in disc magazine
=>Load a disc in the disc magazine.
E-04:
Disc is too dirty. The disc is upside down. The disc is damaged.
=>Clean the disc and insert it correctly.
E-99:
= The unit malfunctions due to a defective CD mechanism.
Press the Reset button.
If the "E-99" message does not disappear, contact your Kenwood dealer.
HOLD:
When the temperature exceeds 60°C, a protection circuit will stop all operations.
This message will
then be displayed.
Let the place where the changer is located cool down.
As soon as it has cooled, the changer starts.
playing.
English 51
apin6
Buljooys
Advertisement
Table of Contents
