Creating Raid Volumes; Deleting Raid Volumes; Marking Disks As Spare - Lenovo 3633 Installation And Service Manual

6. Select Save Settings and press Enter.
7. Exit the Setup Utility program.

Creating RAID volumes

This section describes how to use the Intel Rapid Storage Technology enterprise UEFI HII to create RAID
volumes.
To create RAID volumes, do the following:
1. Start the Setup Utility program. See
2. Select System settings ➙ Storage and press Enter.
3. Select Intel RSTe SATA Controller and press Enter.
4. Select Create RAID Volume and press Enter.
5. Type a proper RAID volume name in the Name field and press Enter.
6. Use the arrow keys to select a RAID level in the RAID Level field and press Enter.
7. Use the arrow keys to select a hard disk drive in the Select Disk field and press Enter.
8. If necessary, repeat step 7 to select multiple hard disk drives.
9. Use the arrow keys to select a stripe size in the Stripe Size field and press Enter.
10. Type a volume size in the Capacity (MB) field and press Enter.
11. Select Create Volume and press Enter.
12. When prompted, press Y to accept the warning message and create the volume.
13. If desired, return to step 4 to create additional RAID volumes.

Deleting RAID volumes

This section describes how to use the Intel Rapid Storage Technology enterprise UEFI HII to delete RAID
volumes.
To delete RAID volumes, do the following:
1. Start the Setup Utility program. See
2. Select System settings ➙ Storage and press Enter.
3. Select Intel RSTe SATA Controller and press Enter.
4. Use the arrow keys to select the RAID volume to be deleted in the RAID Volume field and press Enter.
5. Select Delete and press Enter.
6. When prompted, press Y to confirm the deletion of the selected RAID volume. Deleting a RAID volume
will reset the hard disk drives to non-RAID.
7. After deleting a RAID volume, you can:
• Return to step 4 to delete additional RAID volumes.
• See "Creating RAID volumes" on page 43
• Exit the Setup Utility program.

Marking disks as spare

To mark hard disk drives as spare drives, do the following:
1. Start the Setup Utility program. See
2. Select System settings ➙ Storage and press Enter.
3. Select Intel RSTe SATA Controller and press Enter.
"Starting the Setup Utility program" on page
"Starting the Setup Utility program" on page
for RAID volume creation.
"Starting the Setup Utility program" on page
28.
28.
28.
.
Chapter 4 Configuration information
43