Operation Of Each Special Module Monitor Screen; Screen Configuration, Common Operation And Changing Screens When Monitoring; Composition Of System Configuration Screen And Key Functions - Mitsubishi Electric GOT-A900 Series Operating Manual

12. OPERATION OF EACH SPECIAL MODULE MONITOR SCREEN

Chapter12 Operation of each special module monitor screen
Each screen operation when using the special module monitor function is explained in
this chapter.

12.1 Screen configuration, common operation and changing screens when monitoring

The screen configuration and common operations used when executing the special
module monitor are explained in this section.

12.1.1 Composition of system configuration screen and key functions

This section describes the structure of the system configuration screen that is
displayed after starting the special module monitor function and the key functions
displayed on the screen.
(1) Display
1)
2)
(2) Key functions
Module display
Displays network No. and station No.. of monitor station.
1)
With the module installed in the monitor station, the special function module displays
the format and the initial no. of the I/O signal with the sequencer CPU; the I/O module
displays "Input"/"Output" and the I/O points.
2) For a special function module that cannot be monitored, "Special" and the initial no. of
the I/O signal are displayed.
The display position of the module is the key for moving the special function module
monitor of that module to the screen where it is executed (Touch input)
The keys used for the operation with the System Configuration screen shown in (2) are
3)
displayed. (Touch input)
The chart below shows the functions of the keys that are used with the System
Configuration screen operation.
Key
Monitoring ends; and display returns to the screen where the special module
END
monitor function was begun.
Moves to screen where the special module monitor for that module is
executed. Slots 0 through 7 are valid for each base module.
position
12 - 1
MELSEC
The module format and related data are
displayed at the end of the module data
readout from the PLC CPU.
(OS executes it automatically.)
When connected to MELSECNET, the
screen shown in Section 12.1.3 is
displayed.
3)
Function
GOT
12