Safety Instructions - Pioneer SA-570 Operating Instructions Manual

Table of Contents

Advertisement

REAG
INSTRUCTIONS
Alt
the
safety
end
'operating instructions should be read befora the
appliance le operated.
RETAIN INSTRUCTIONS
— The operating instruc-
tlons shoukd be retained for fusure esferenca
HEED WAANING
— Ail warnings on the appliance
'and in the operating instructions shouid be adhered
to.
FOLLOW INSTRUCTIONS
~ All operating and use
inatructions should be followed.
WATER
AND MOISTURE
— The appliance should
not be used near wster — for exampie, near a
bathtub, washbowl, kitchen sink, laundry tub, ina
wet basement, or near 8 swimming pool, etc.
LOCATION
— The appliance should be installed in a
stable location.
WALL OR CEILING MOUNTING
— The
appliance
should not be mounted to a wall or ceiling.
VENTILATION — The appliance shouid be situated so
that its location or position does not interfere with
its propar ventilation. For exampie, the appliance
should not be situated on 8 bed, sofa, rug, or
similar surface that may block the ventilation open-
ings; or, placed in a built-in installation, such as a
bookcase or cabinet that may impede the flow of
air through the ventilation openings.
HEAT — The appliance should be situated away from
heat sources such as radiators, heat registers,
stoves, or other appliances {including amplifiers)
that produce heat.
POWER SOURCES
— The appliance should be con-
nected to a power supply only of the type describ-
ed in the operating instructions or as marked on the
appliance,
POWER-CORD PROTECTION — Power-supply cords
should be routed so that they are not likely to be
waiked on or pinched by items placed upon or
against them, paying particular attention to cords
at plugs, convenience receptacles, and the point
SAFETY INSTRUCTIONS
POWER LINES — An outdoor antenna should be
located away from power lines.
NONUSE PERIODS — The power cord of the ap-
piiance should be unphigged
from the outlet when
eft unused for 2 long period of time.
OBJECT AND LIQUID ENTRY — Care should be
taken 30 that objects do not fail and liquids are not
apilied into the enclosure through openings.
DAMAGE REQUIRING SERVICE — The appliance
should be serviced by Pioneer authorized service
center oF qualified service personnel when:
*
The power-supply cord or the plug has besn
damaged; or
*
Objects have fallen, or liquid has been spilled into
the appliance;
or
*
~The appliance has been exposed to rain; or
©
The appliance doas not appear to operate normally
or exhibits a marked change in performance; or
*
The appliance has been dropped; or the enclosure
damaged.
SERVICING
— The user should not attempt to service
the
appliance
beyond
that
described
in
the
operating instructions. For all other servicing, con-
tact the nearest Pioneer authorized service center.
senvice
ENTRANCE
CONDUCTORS
+
OUTDOOR ANTENNA GROUNDING — 4 an
outside antenna is connected to the antenna
terminal, be sure the antenna system is
artounded so as to provide some protection
against vollage surges and bulk up sistic
charges.
in the U.S.A. section 810 of the Natianal Siec-
vical Code, ANSI/NFPA No. 70-1884, pro-
vides information with respect to proper
grounding of the mast and supporting struc-
ture, grounding of the jead-in wire to an anten-
na discharge unit, size of grounding conduc-
tors, location of afitenna-discharge unit, con-
nection to grounding electrodes, and re-
quirements for the grounding electrode. See
Fig. A.
a} Use No. 10 AWG (5.3 mm?)
copper, No. 8 AWG (8.4
mm?) aluminum, No. 17
AWG {1,0 mm) copper-
clad steel, bronze wire, or
larger as ground wire.
b) Secure antenna lead-in and
3
i
:
INSULATORS &
ground wires to house with
stand-off insulators spaced
from 4 feet (1.22 meters) to
6 teot (1.83 meters) apart.
¢] Mount antenna discharge
ANTE ag
Unit as closely as possible to
'
where lead-in enters house.
a
To exrennaL awrenva — d)_- Use jumper wire not smaller
y
where they exit from the appliance.
POLARIZATION
ff your purchased product is pro-
following instructions, This product is equipped
with a polarized alternating current ine plug (a plug
having one blade wider than the other). This plug
will fit into the power outlet only one way. This is a
safety feature. If you are unable to insert the plug
fully into the outlet, try reversing the plug. If the
plug should still fail to fit, contact your electrician
to replace your obsolete outlet. Do not defeat the
safety purpose of the polarized plug.
ghouwo
4 gRouno
2
Cagaes
Power seavice
GROUNDING ELECTAOOE SYSTEM
than No.6 AWG (13.3 mm?)
copper or equivalent when
na
DiScheance Unt
separate antenna-ground-
ing electrode is used.
cabinet.
IMPORTANT 1
The lightning flash with arrowhead,
within an
equilateral triangle, is intended to alert the user of the
presence of uninsulated "dangerous voltage" within the
product's enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to persons.
IMPORTANT 2
if the apparatus is fitted with AC mains power outiet(s),
see REAR
PANEL
FACILITIES for convenient connec-
tion of additional Hi-Fi componentis}. Make all connec-
tions to the AC outtet(s) and the signal terminals first.
Connect the plug to the wall socket last, make sure that
the power switch is off. Disconnect the wall plug when
the equipment
is not in (regular) use,
e.g. when
on
vacation.
2
<ARB1028>
CAUTION
RISK OF ELECTRIC
SHOCK
DO NOT OPEN
CAUTION:
TO PREVENT THE RISK OF ELECTRIC SHOCK, DO.
NOT
REMOVE
COVER
(OR
BACK}.
NO
USER-
SERVICEABLE
PARTS INSIDE.
REFER SERVIC-
ING TO QUALIFIED SERVICE PERSONNEL.
FOR USE IN THE UNITED
KINGDOM
The wires in this mains lead are coloured in accordance
with the following code:
Blue:
Neutral
Brown:
Live
The exclamation point within an equilateral triangle is
intended to alert the user of the presence of important
operating and maintenance (servicing) instructions in
the literature accompanying the appliance.
As the colours of the wires in the mains fead of this ap-
paratus may not correspond with the coloured marking
identifying the terminais in your plug proceed as
follows:
The wire which is coloured blue must be connected to
the terminal which is matked with the letter N or col-
oured black.
The wire which is coloured brown must be connected to
the terminal which is marked with the letter L or col-
oured red.
Equipment sold in the U.K. is not supplied with a
power plug.

Advertisement

Table of Contents
loading

Table of Contents