Wall Installation - Uniden EXV 98 Owner's Manual

HINT
Before choosing a location
for your phone, read the
"Installation Considerations"
included in the "Precautions
and Important Safety
Instructions" brochure.
CAUTION
Place the power cord so
that it does not create a
trip hazard or where it
could become chafed and
create a fire or electrical
hazard.
!
NOTE: DO NOT use an
outlet controlled by a
wall switch.
4

WALL INSTALLATION

Standard wall plate mounting
This phone can be mounted on a
standard AT&T or GTE wall plate.
To attach the wall mount adapter to
the base:
1) Slide the wall mount adapter into the
notches at the top of the base.
2) Pivot the wall mount adapter down and
snap into place.
3) Plug the AC adapter into the base.
4) Wrap the AC adapter cord around
the strain relief notch. Then, put the AC
adapter cord inside the molded wiring
channel. Plug the AC adapter into a
standard 120 VAC wall outlet.
5) Plug one end of the short
telephone cord into the
TEL LINE jack on the base.
Place the telephone cord
inside the molded channel
on the bottom of the base.
Before you plug the other
end of the telephone cord
into the modular jack on
the wall, charge the battery
(refer to "Charging the Battery Pack," page 6).
6) Place the base on the posts
of the wall plate and push
down until it's firmly
seated.