Uniden DXAI3288-2 Series Owner's Manual page 12

• Use only the supplied
AD-314 AC adapter
for the base and AD-
310 for the charging
cradle. Do not use
any other AC adapter.
• Place the power cord
so that it does not
create a trip hazard
or where it could
become chafed and
create a fire or
electrical hazard.
The handset can be
placed face up or
face down in the
base for charging.
[ 10 ] G E T T I N G S T A R T E D
C. Connect the base unit and charging cradle
1) Connect each AC adapter to the DC IN 9V jack
and to each standard 120V AC wall outlet.
2) Set the base and charging cradle on a desk or
tabletop, and place one handset on the base unit
and one in the charging cradle. (For wall mounting,
see "Mounting the Base Unit on a Wall", on page 13.)
3) Raise the antenna to a vertical position.
4) Make sure the charge/in use and charge LED
illuminates. If the LED does not illuminate, check
to see that the AC adapter is plugged in and the
handset makes good contact with the cradle's
charging contacts.
• Connect the AC adapter to a continuous power supply.
• Place the base unit and charging cradle close to the AC
outlets so that you can unplug the AC adapters easily.
After installing the battery packs in the handsets, charge your handsets at least
15-20 hours before plugging into the phone line.
5) Once the handset battey packs are fully charged,
connect the telephone line cord to the TEL LINE
jack and a telephone outlet.
If your telephone outlet isn't modular, contact
your telephone company for assistance.
Modular
www.uniden.com