Uniden BC895XLT User Manual page 35

If you want to program tones for several stored frequencies, follow these steps:
After you program a CTCSS tone with a stored frequency, the CTCSS Tone Search Mode
is canceled. The CTCSS indicator remains on but does not flash. To activate the CTCSS
Tone Search Mode again, press and hold
If you decide to cancel the CTCSS Tone Search Mode while scanning, press and hold
K
until you hear two short beeps and the CTCSS indicator turns off.
You can select the CTCSS Search Mode before pressing
K
until the CTCSS indicator begins flashing, and then press
When your scanner stops, the CTCSS Tone Search begins immediately. If a tone is found
before the transmission ends, press
the channel.
Using CTCSS Tone Search While Searching
1. Set a Search Range.
For information about setting a search
range, see Setting a Search Range on
page 30.
S
2. Press .
3. Press and hold
short beeps.
CTCSS begins flashing in display.
The scanner starts searching for an
associated CTCSS tone when it stops on
a transmission. All 38 tones are checked
if the transmission is long enough.
However, if you press
break before a tone is identified, the tone
search starts where it left off when the
transmission begins again.
K
until you hear two
h
, and there is
K
until you hear two short beeps.
e
to program the tone with the frequency stored in
SCAN
PRI TRUNK
L/O DELAY
35
s
. Simply, press and hold
s
.
MANUAL
2
1
4
5
DATA
8
7
CTCSS
0
3
6
9
E