Speaker Cables - Technics SC-HD510 Operating Instructions Manual

Basic connections for supplied :
accessories
and N.Z.) and speaker cables, twist the vinyl tip and pull off
@).
Before connection
@ Do not connect the AC mains lead until all other connections
are complete.
To prepare the AM loop antenna, FM antenna (for Australia
(
Disconnect the flat cable on the cassette deck (©).
1° Flat cables.
Keep the cables as flat as possible against the back of the
unit. :
FM antenna.
Fix the other end of the antenna where reception is best.
GQ N AM loop antenna.
Keep loose antenna cord away from other wires and cords.
4 Speaker cables.
Connect the cables to the terminals of the same color. Never.
allow the exposed wires to contact each other when
connected.
Use only the supplied speakers.
The combination of the system and the front speakers
provides the best sound. Using other speakers can damage
the unit and sound quality will be negatively affected.
(United Kingdom only)
BE SURE TO READ THE CAUTION FOR THE AC
MAINS LEAD ON PAGE 4 BEFORE PROCEEDING
TO STEP 5.
5 Connect the AC mains lead.
Insertion of connector
Even when the connector is perfectly inserted, depending on
the type of inlet used, the front part of the connector may jut
out as shown in the drawing.
However there is no problem using the unit.
Connector
tH
Approx. 6 mm
Appliance inlet
For your reference
Information you enter into the unit's memory, except for time,
remains intact for up to two weeks after the mains lead is
disconnected.
The included AC mains lead is for use with this unit only. Do not use
it with other equipment.
Before use hat
7
RQT5296