Connecting For Power; Using Headphones; Demo Mode; Restore To Factory Settings - RCA RT2250 Manual

Hide thumbs Also See for RT2250:

Table of Contents

RT2250

ENG

1/6/00

9:37

Page

Connecting for Power

Make sure you connect all your other electronic components and the

speakers before plugging your receiver into the outlet. Plug the power cord

in the wall outlet, matching the wide blade of the plug with the wide slot

in the outlet. Be sure to insert the plug completely.

Using Headphones

To listen privately through your audio system, use the PHONESjack on the

receiver. However, make sure you turn down the volume before you put on

the headphones. Increase the volume to the desired levelafter headphones

are in place.

Once headphones are connected, "HEADPHONE DOWNMiX 2

CHANNEL" will scroll on display.

Demo Mode

Right after you have plugged in the power, a demo messagewill appear in display. It wilt also be displayed if

you pressthe SETIDEMO at STANDBY mode or press a source button ( like CD)but then leave all buttons

untouched for 30 seconds. To restore to normal status, press SET/DEMO again to return to STANDBY mode.

Restore to Factory Settings

You can always restore all settings back to original state. When the receiver is in STANDBY mode, press accord-

ingly as:

STADIUM _

NIGHT _

DSPOFF

CLUB

then you can restore everything like preset radio station frequencies, speaker settings,etc, back to the first

time you use it.

Note: As you turn on the receiver, it will first enter TUNER mode and show frequency as 87.5MHz after the

settings have been restored.

"'., .......................................................................................................................

.o-"

Table of Contents

Rt2250r