Summary of Contents for Paramount Fitness Paralevel
Page 1
004-027-8883-00 R00 ECN_2363 PUB030823 Paralevel Float Assembly Seal Replacement Kit Installation Manual Contents Overview.........1 Installation......1 Operation.......5 005-762-2932-00 Paramount 8175 W. Buckeye Rd., Phoenix, AZ 85043 Phone: (480) 893-7607 www.1Paramount.com USE ONLY PARAMOUNT GENUINE REPLACEMENT PARTS...
Page 2
Follow the steps below to install the Paralevel float assembly kit. Turn off the water supply to the Paralevel. Remove the Paralevel float assembly by grasping the top of the float assembly and while pushing down turn the assembly counter clockwise a quarter turn.
Page 3
There is a white o-ring seal at the bottom end of the float assembly. Peel off to remove. Slide a new white o-ring over the end and into the groove to replace. White o-ring seal Next, spread the retainer ring at the bottom end to remove it from the groove and slide it to the bottom of the shaft.
Page 4
Grab the top cap seal arm and twist away from the snap swivel that has the opening in it. Pull the top cap seal arm out of the top of the float assembly. Pull out of the float assembly. Twist top cap seal arm away from snap swivel with the...
Page 5
Re-installing float assembly: • Start with float 1/4 down from the top on sleeve adjuster. • Position the end of the riser tube with the o-ring inside the opening at the top of the nut retainer. • Turn the riser tube clockwise and wiggle until it drops into the nut retainer. Too much downward pressure before it sets into the opening of the nut retainer will cause the float assembly to hang up.
Page 6
Turn on water supply at source fully. • Start with the float high and the leveler allowing water to flow. • Turn the float clockwise 1/2 turns at a time until the Paralevel shuts off. USE ONLY PARAMOUNT GENUINE REPLACEMENT PARTS...
Page 7
USE ONLY PARAMOUNT GENUINE REPLACEMENT PARTS...