HAMPTON BAY LELAND II Use And Care Manual page 10

Assembly — Hanging the Fan (continued)
Making the electrical
6
connections
WARNING: To avoid possible electrical shock, be sure
electricity is turned off at the main fuse box before wiring.
WARNING: Check to see that all connections are tight,
including ground, and that no bare wire is visible at the wire
nuts (AA), except for the ground wire.
WARNING: To reduce the risk of fire or electric shock, do
not use this fan with any solid-state speed control device.
If you feel you do not have enough electrical wiring
knowledge or experience, have your fan installed by a
licensed electrician.
Follow the steps below to connect the fan to your
household wiring. Use the plastic wire nuts (AA) with your
fan. Secure the wire nuts (AA) with electrical tape. Make
sure there are no loose strands or connections.
□
Connect the ground conductor (TT) of the 120V supply
(this may be a bare wire or a wire with green colored
insulation) to the green ground lead(s) (XX) of the fan
using a plastic wire nut (AA).
□
Connect the fan motor white wire (WW) to the supply
white (neutral) wire (SS) using a plastic wire nut (AA).
□
Connect the fan motor black wire (VV) and the blue
wire (UU) to the supply black (hot) wire (RR) using a
plastic wire nut (AA).
□
Turn the wire nut (AA) connections upward, spreading
them apart so the green (ground) wire (XX) will be on
one side of the outlet box (PP) and the white (WW),
black (VV) and blue (UU) wires will be on the other
side, and push them carefully up into the outlet box
(PP).
RR
AA
10
SS
TT
PP