Yamaha GRIZZLY 550 2010 Owner's Manual page 26

EBU18101
Start switch " "
Push this switch to crank the engine with the start-
er. See the starting instructions on page 6-1 prior
to starting the engine.
EBU18152
Light switch "
Set this switch to "
4
and the taillight. Set the switch to "
the high beams and the taillight. Set the switch to
"OFF" to turn off all the lights.
ECB00041
NOTICE
Do not use the headlights with the engine
turned off for an extended period of time, oth-
erwise the battery may discharge to the point
that the starter motor will not operate properly.
If this should happen, remove the battery and
recharge it. See page 8-56 for battery charging
information.
/ /OFF"
" to turn on the low beams
" to turn on
EBU18190
Override switch "OVERRIDE"
1. Override switch "OVERRIDE"
Top speed is normally limited when operating in
differential gear lock. If conditions require more en-
gine power when riding forward, push and hold this
switch to override the differential gear lock speed
limiting function. (See page 4-10.) Releasing the
switch restores the speed limiting function.
While the override switch is pushed, the segments
of the speedometer digits will appear as shown in
the figure.
4-8