KTM 450 EXC-F Six Days 2017 Setup Instructions page 11

2 SETUP
–
Route the turn signal wiring harness from front to back as far as the battery
compartment.
–
Position and secure the turn signal wiring harness under the rubber bands of
the fuel tank contact area on the main wiring harness.
S01418-01
–
Remove screw
–
Remove screw
–
Pull off the side cover in area
rear.
E00494-10
–
Detach spring
Spring hook (50305017000)
–
Remove screws
E00487-10
–
Pull the EFI control unit from the holder and hang it to one side.
–
Disconnect and remove plug-in connector
–
Join the plug-in connector of the turn signal wiring harness with the plug-in
connector of the main wiring harness.
S01417-10
–
Remove screw
–
Remove screw
–
Remove screw
E00489-10

.

.
 and in area

.

with washers and take off main silencer.

with the collar sleeve.

.

with negative cable and contact disk.
 and remove it toward the

on the main wiring harness.
9