Advertisement
SERVICING
=
=
©.
|
[en
problems are due to lack of simple maintenance or oversights and can be solved
easily without having to call the Servicing Department.
m PROBLEM
E THE MACHINE DOES
NOT START UP
(with pilot light off)
(with pilot light on)
m THE MACHINE DOES NOT FILL
m THE MACHINE EMPTIES AS IT
FILLS
O The programme dial has not been
pulled outwards
e The door is not closed properly
e The appliance is not plugged in
O There is no electric supply from the
wall socket
e The
programming
dial is not
correctly positioned
e No water is entering the machine
e The water tap is not on
e The water supply has been cut off
@ The inlet hose is bent
e The water pressure is too low
@ The water inlet filter is clogged
e The end of the drain hose is too low
@ The
end
of the drain hose
is
submerged in water
e Drain pipe without vent-hole
> SOLUTION
» Pull the dial outwards
» Close the door
» Plug the appliance in
> Check the fuse
> Consult a qualified electrician
> Press and turn the programme
dial to the selected
programme
P See solutions to the problem: THE
MACHINE DOES NOT FILL
> Turn the tap on
> Wait until the water supply is
restored
P Straighten the bend out
> If this occurs often, consult a qualified
plumber
» Clean the filter (see page 24)
> Position the drain hose at the correct
height (between 60 and 90 cm)
> The end of the drain hose must NOT
be submerged
> Consult a qualified plumber
W THE
MACHINE
DOES
NOT
DRAIN OR SPIN
e You have depressed the Rinse Hold
push button
e The drain filter is clogged
e The drain hose is bent
e The
drainage
system
pipes are
blocked
o The
drain
hose
extension
is
incorrect
P Press in again the button or select
programme M
P Clean the filter. Before doing this,
see page 24.
> Straighten the hose out
> Consult a qualified plumber
> Consult a qualified plumber
Advertisement
