Heathkit SB-1000 Manual

()
()
()
Heathkit® Manual for the
LINEAR AMPLIFIER
Mode! SB-1000
595-3795-01
Please perform the following steps and assemble your
3-ring binder before you assemble your kit. De not
unpack your kit until you are instructed to do so.
Refer to Figure 1, locate the envelope marked
"Binder Hdw", and remove the hardware.
Position the binder cover with the large hole as
shown.
Determine which side of the rings unhook. Then
position the ring assembly as shown and mount
it to the cover with the binder hardware: two 6-
32 x 3/8" nylon screws, two flat washers, and
two 6-32 nuts as shown. Do not overtighten the
hardware.
Ifit has not already been done, carefully remove
the Manual and its Illustration Booklet, Sche-
matic, etc. from its wrapping.
Unfasten the rings (if they are fastened) and
place the Manual in the binder. Set the Illustra-
tion Booklet and any other Manual portions
aside.
HEATH COMPANY
BENTON HARBOR, MICHIGAN 49022
()
Refasten the rings.
Discard this page and proceed with your Man-
ual. NOTE: Install the Mustration Booklet and
any other Manual portions in the back of the
binder after you assemble your kit.
Figure 1
Copyright © 1987
Heath Company
All Rights Reserved
Printed in the United States of America