Table of Contents
Advertisement
Supplying Power
Battery Refresh Feature
This feature completely discharges the Battery before recharging begins,
To maintain your Battery's operating capacity, use the refresh feature after about every five charges.
CHARGE Lamp
Battery Care
Caution:
* Charge onty with specifled charger.
* Battery can be charged within a temperature
range of-32? F (0° C) and 104° F (40? C).
* Battery may be warm after charging or just
after use. This is normal.
* Do not use an insufficiently charged or worn-
out Battery.
Safety precautions:
. "ie not get the Battery near, or dispose of in
tre.
* Do not directly connect (short circuit) the
positive (+) and negative (—) terminals.
* Never attempt to disassemble or reassemble
the Battery.
U.S.A. CONSUMERS:
ATTENTION:
The product you have purchased is powered by a nickel cadmium battery which Is
1 Plug In the AC Adaptor.
* The POWER Lamp remains lit as long as the
AC Adaptor is plugged in.
2 Place the Battery into
the AC Adaptor.
button.
The CHARGE Lamp flashes until
discharge is complete and then stays lit
until the Battery is fully charged.
e PERREN the Battery.
* Should you accidentally press the BATTERY
REFRESH button, remove the Battery and
then re-insert it to begin charging.
* [t takes about seven and a half hours when
both Battery Refresh and recharging are
performed.
To avoid damage to the Battery:
* Do not drop or jar Battery.
* Use Battery with specified units only.
* If Battery is used in extremely high tempera-
tures, a safety device will automatically
prevent operation.
To prolong battery life:
* While not in use, remove Battery from the
Palmcorder and AC Adaptor and store in a
cool, dark, dry place.
* Keep Battery terminals clean.
recyclable. At the end of its useful tife, under various state and local laws, it is illegal to
dispose of this battery into your municipal waste stream. Please call 1-800-8-BATTERY
for information on how to recycle this battery.
Advertisement
Table of Contents
