Table of Contents
Advertisement
Checking the Level
When pushing down the edges of the
top plate diagonally, the appliance
should not move up and down at all
(check both directions).
• If the appliance rocks when pushing
the top plate of the appliance
diagonally, adjust the feet again.
• Check whether the appliance is
perfectly level after installation.
NOTE
• Timber or suspended type flooring
may contribute to excessive vibration
and unbalance. Reinforcement or
bracing of the timber floor may need
to be considered to stop or reduce
excessive noise and vibration.
• Never try to level any uneven floor by
putting pieces of wood, cardboard or
similar materials under the appliance.
Adjusting and Levelling the
Feet
When installing the appliance, the
appliance should be aligned and
perfectly level. If the appliance is not
aligned and level properly, the appliance
may be damaged or may not operate
properly.
1
Loosen the plastic locking nut.
• Do not insert pieces of wood etc.
under the feet.
INSTALLATION
• Make sure that all four feet are
stable and resting on the floor.
NOTE
• Do not install the appliance on a plinth,
stand or elevated surface unless it is
manufactured by LG Electronics for
use with this model.
2
To increase the height of the
appliance, turn the feet clockwise. To
decrease the height of the appliance,
turn the feet anticlockwise..
3
Check if all lock nuts at the bottom of
the appliance are secured properly.
NOTE
• Proper placement and levelling of the
appliance will ensure long, regular,
and reliable operation.
• The appliance must be 100%
horizontal and stand firmly in position
on a hard flat floor.
• It must not 'Seesaw' across corners
under the load.
• Do not let the feet of the appliance get
wet. Failure to do so may cause
vibration or noise.
15
1
Advertisement
Table of Contents
