Panasonic CY-VM5800U Operating Instructions Manual page 20

2 SO-FOSN
20
Installation Guide (continues)
(7 Connect All Leads
Now that you have identified all the wires in the car,
you're ready to begin connecting them to the con-
troller unit wires. The connection diagram (= pages
21, 22) shows the proper connections and color
coding of the leads.
We strongly recommend that you test the unit
before making a final installation.
You can set the unit on the floor and make tempo-
rary connections to test the unit. Use electrical tape
to cover all exposed wires.
Important:
e Connect the red power lead last, after you
have made and insulated all other connec-
tions.
Ground
Connect the black ground lead of the power connec-
tor to the metal car chassis.
Power
Connect the red power lead to the correct car radio
wire or to the appropriate fuse port on the fuse
block. NP |
If the LCD monitor functions properly with all these
connections made, disconnect the wires and pro-
ceed to the final installation.
O Final Installation
Lead Connections
Connect all wires, making sure that each connection
is insulated and secure. Bundle all loose wires and
fasten them with tape so they won't fall down later.
Congratulations! After making a few final checks,
you are ready to enjoy your new auto LCD monitor.
(3 Final Checks
1. Make sure that all wires are properly connected
and insulated.
2. Turn on the ignition to check the unit for proper
operation.
If you have difficulties, consult your nearest autho-
rized professional installer for assistance.
«Installation Example»
Warning
o Where and how this unit is installed differs according to the car model concerned. As such, the informa-
tion contained in this installation guide is designed for professional installers and is not intended for non-
technical individuals.
GYEVM5800U