Before First Use; Daily Use - AEG LR7BREMEN User Manual

22 www.aeg.com
1. Switch the appliance on by pressing
Aan/Uit button.
2. Turn the programme knob to the first
programme.
3. Press and hold the Vlekken/Voorwas
and Plus Steam buttons for some
seconds (within 10 seconds after the
switching on. After these 10 seconds,
the key combination activates and
deactivates the acoustic signals).
4. After 3 seconds the total hours
operated by the appliance are shown
in the display: e.g. 1276 hours, the
display shows the text Hr for 2
seconds, 12 (thousands and
hundreds) for 2 seconds and 76 (tens
and units).
If the procedure does not
work (due to timeout, wrong
programme dial position or
wrong keys combination),
switch the appliance off and
repeat sequence from the
beginning.
10.4 Factory Reset
This function allows to restore the factory
default options. To activate this option
follow steps below:

11. BEFORE FIRST USE

1. Make sure that all transit bolts have
been removed from the appliance.
2. Make sure that the electrical power is
available and the water tap is open.
3. Pour a small quantity of detergent
into the compartment marked

12. DAILY USE

WARNING!
Refer to Safety chapters.
12.1 Activating the appliance
1. Connect the mains plug to the mains
socket.
2. Open the water tap.
3. Press the Aan/Uit button for a few
seconds to activate the appliance.
1. Switch the appliance on by pressing
Aan/Uit button.
2. Turn the programme knob to the third
programme.
3. Press and hold the Vlekken/Voorwas
and Plus Steam buttons for some
seconds (within 10 seconds after the
switching on. After these 10 seconds,
the key combination activates and
deactivates the acoustic signals).
4. The display will show
about 5 seconds.
If the procedure does not
work (due to timeout, wrong
programme dial position or
wrong keys combination),
switch the appliance off and
repeat sequence from the
beginning.
4. Set and start a programme for cotton
at the highest temperature without
any laundry in the drum.
This removes all possible dirt from the
drum and the tub.
.
A short tune sounds (if activated). The
appliance automatically proposes a
default programme. The relevant
indicator illuminates.
The display shows the maximum load,
the default temperature, the default spin
speed, the indicators of the phases
making up the programme and the cycle
duration.
for