Controlling The Repeater By Remote Control (Remote Control); Remote Control - Kenwood NXR-1700 Function Reference

11 CONTROLLING THE REPEATER BY REMOTE CONTROL (REMOTE CONTROL) / 11.1 Remote Control
11 CONTROLLING THE REPEATER BY REMOTE CONTROL (REMOTE
CONTROL)
Remote Control is the function to remotely control the repeater via Web by using the Web Tool.

11.1 Remote Control

The repeater supports the Remote Control function via Web. Remote Control means that the repeater is controlled
remotely. The supported range is as follows:
Function
Channel Select
Slot Select
CW ID
Decode Signaling Enable/Disable
Encode Signaling Enable/Disable
Call Hangtime Enable/Disable
Channel Hangtime Enable/Disable
Hold Time Enable/Disable
Local TX Enable/Disable
Low Power On/Off
Monitor On/Off
AUX Output Control
Repeat Enable/Disable
Squelch On/Off
Take Over On/Off
Test Tone On/Off
TOT Enable/Disable
TX Enable/Disable
Voting Tone On/Off
Knob Lock/Unlock
Service Stop
Service Start
Service Restart
Service Reboot
Active Status Switch
FUNC (E)/ Ver 2.00
Table 11-1 Remote Control
Remarks
The "Apply" button is pressed after entering the desired channel
number.
The "Apply" button is pressed after entering the desired slot number.
A CW ID is sent by pressing the button.
Pressing the button starts the toggle behavior.
Pressing the button starts the toggle behavior.
Pressing the button starts the toggle behavior.
Pressing the button starts the toggle behavior.
Pressing the button starts the toggle behavior.
Pressing the button starts the toggle behavior.
Pressing the button starts the toggle behavior.
Pressing the button starts the toggle behavior.
Pressing the button starts the toggle behavior.
Pressing the button starts the toggle behavior.
Pressing the button starts the toggle behavior.
Pressing the button starts the toggle behavior.
Pressing the button starts the toggle behavior.
Pressing the button starts the toggle behavior.
Pressing the button starts the toggle behavior.
Pressing the button starts the toggle behavior.
Pressing the button starts the toggle behavior.
Pressing the button stops the repeater software.
Pressing the button starts the behavior of the repeater software.
Pressing the button stops the repeater software, and then the repeater
software starts the behavior.
Pressing the button makes the repeater reset the hardware level, and
then the repeater restarts and starts the behavior.
The Active state of Hot Standby can be switched.
145