Installing Optional Castors - True TCGR-50 Installation Manual

True Food Service Equipment, Inc.
OPTIONAL (INSTALLING OPTIONAL CASTORS)
CASTOR INSTALLATION:
TOOLS REQUIRED:
• Castor wrench (if not included contact True)
• Adjustable wrench
NOTE
Castors not available for hard wired or remote
models.
WARNING
Make sure unit is empty of all its contents (shelv-
ing, shelving lighting). Make sure power supply
has been disconnected.
A. Curved glass can be damaged if you lay unit
on its back, side, or front. Use a 6" x 6" (15.2
cm x 15.2 cm) block of wood or equivalent.
Slide the block under the cabinet frame rail.
This will support the unit while installing
castors.
B. Leg levelers can be backed out by hand
(image 1).
C. Take two threaded castors and thread them
into the existing leg leveler holes. (image 2).
Shims can be used between castor and cabi-
net frame rail for leveling (image 3). Use the
tool provided to tighten the threaded castors
(image 4).
D. Repeat process for the other side of the cab-
inet.
Warning
Display case must be leveled accurately to ensure
front glass door seals properly.
E. The unit should
be leveled front to
back and side to
side with a level.
Place the level in
the interior floor of
the unit and check
all four sides.
11
INSTALLATION / OPERATION INSTRUCTIONS
Tighten castor in position with castor
wrench.
............ www.truemfg.com ............
Back out leg levelers by hand, or with
adjustable wrench.
Thread castors into existing leg leveler
holes.
4
Use shims as necessary to level cabinet.
1
2
3
11