Care And Maintenance; Factory Reset The System - Bose CineMate 130 Owner's Manual

Care and Maintenance
No power
No sound
e
e
e
e
e
e
e
e
e
e
e
e
e
e
e
e
e
Sound is *
coming from
your TV •
speakers
o
Remote
control is
inconsistent
e
or does not
work
e
o
Secure the Acoustimass ® module's, soundbar's and console's
power cords.
Reconnect the Acoustimass module's, soundbar's and console's power
cords firmly into an AC (mains) outlet.
Use the remote control to power on the system.
Factory reset the system (see page 32).
Unmute the system.
Increase the volume.
Plug the Acoustimass module, soundbar and console into a live AC
(mains) outlet.
Insert the speaker cable into the Speaker Connections connector, not
the Bose ® Link connector.
Insert the HDMI
TM
cable into a connector on your TV labeled ARC or Audio
Return Channel. If your TV does not have an HDMI ARC connector, use a
secondary audio cable in addition to the HDMI cable (see page 13).
If using a secondary audio cable, insert the cable into a connector on your
TV labeled Output or OUT, not Input or IN.
Secure all cable connections on the soundbar, TV and connected sources.
If your source is connected to your TV, select the correct TV input
(see page 25).
Disconnect headphones when not in use.
• ¢h
If connecting your source through the _.' connector, enable Audio in
using the System menu (see page 27). _
If you are connecting headphones to the -_ connector, enable
Headphones using the System menu (see page 27).
If you see the error message Cannot find Acoustiraass, pair the
Acoustimass module with the console (see page 31).
Factory reset the system (see page 32).
Insert the HDMI cable into a connector on your TV labeled ARC or
Audio Return Channel (if available).
Turn off your TV speakers (refer to your TV owner's guide).
Decrease your TV volume to its lowest setting.
Match the + and - symbols on the batteries with the + and - markings
inside the compartment (see page 18).
Replace the battery (see page 18).
Press the volume button on the remote control and see if the correct
source button flashes.
If using CEC:
- Point the remote control at the console.
- Program the remote to control your source (see page 24).
If you have programmed the remote to control your source:
- Point the remote control at the appropriate source.
- Ensure you have entered the correct code for your source's brand.
- Program the remote with another code (see page 24).
30 - English