Field-Level Test Checklist - Motorola iDEN i265 Field Service Manual

FIELD LEVEL TEST MODES AND PROCEDURES: Field-Level Test Checklist
2. Press #.
3. Press *.
4. Press Menu three times.
5. Press the left Scroll key.
6. Press Menu twice.
7. Press the left Scroll key. You now are in test mode.
To exit test mode, press the option key under Exit. The unit waits for a few seconds, resets, and
then re-registers the unit.
The following tests are performed in test mode:
TX Power Test
•
RX BER Tests
•
800BER1
800BER2
800BER3
800BER4
900BER1
900BER2
900BER3
NOTE: The Power, MPX, and MOD test parameters are for factory use only and should not be
adjusted by field service personnel. The default values for these parameters are as
follows:
Power: 0 dB
MPX: 1:6
MOD: QAM16
8.3

Field-Level Test Checklist

Use the following test checklist to ensure that all the necessary tests are performed and to provide
a tracking mechanism in case the unit is sent to the next level of service.
Check the appropriate box for each test performed and indicate whether or not the test was
completed successfully.
8-2
68P80400P84-O