Download Print this page

Kenwood DP-560 Instruction Manual page 10

Compact disc player
Hide thumbs Also See for DP-560:

Advertisement

B Repeat playback
Repeat playback can be activated or canceled any time, i.e.
when the tray is open, during memory or normal playback.
When the REPEAT key is pressed, the indicator will light.
e
During memory playback, repeat playback is activated on-
ly from the trackes programmed in memory.
®
During normal playback, all tracks are repeated.
@
To cancel repeat playback, press the REPEAT key again,
press the STOP key, or open the tray.
Note:
Repeat playback is also canceled when TOC has been read.
SR
SG
ae
oo eT
10 op-seo tk)
EWUl
OG
WIbEbEG
Should this unit require servicing, be sure to repack the unit
with original carton box and material.
Sending the unit without repacking may result in damaged
finish or malfunction.
Before repacking, be sure to secure the laser pick-up system
with the transportation screws as follows.
1. Turn the power ON without loading disc.
2. Turn OFF the power after the display shows the following
indication.
ia 50.
ane
myn
[ ey
iu
H
3. Install the transportation screws.
Notes on handling compact dises
Handling
Compact discs are made of plastic (polycarbonate). When the
recorded
side of the compact
disc is dirty or scratched,
playback may be noisy or sound may be missed. Even when
the label side is scratched, the recording may be damaged.
Handle compact discs carefully. Do not stick tape, etc. to
compact discs.
Cleaning
When a compact disc is contaminated with fingerprints, etc.,
wipe with a dry cloth in a radial direction. Never use chemical
solvents, such as thinner, benzene, etc. anid conventional
record cleaners or aerosols.
Storage
Always replace the compact disc in its case and store it. Com-
pact discs are adversely affected by heat and moisture. Do
not store compact discs in a place exposed to direct sunlight
or where humidity is high.
Additional precautions
When performing connections, always disconnect the power
cord from the AC outlet. When
setting the power switch
(POWER)
to OFF, always turn the volume
control of the
amplifier to minimum.

Advertisement

loading