JVC AV-48WP34/AHA Service Manual page 18

AV-48WP30
! SCREEN ASS'Y
" Remove the SPEAKER GRILLE.
" Remove the FRONT CONTROL BOX.
1. Remove 4 screws G under the SCREEN ASS'Y from front side.
2. Remove 10 screws H from rear side.
3. Remove the SCREEN ASS'Y.
NOTE :
" Place the screen with face upwards on a flat stand.
" Because of the large size, at least two parsons are
recommended for removal and reassemble.
" Use core not to scratch the screen during work.
" During assembly, be sure to engage the left and right tabs
with the cabinet mounting positions.
" When than sporting the SCREEN ASS'Y, avoid grasping the
top of the screen panel, instead grasp the left and right areas.
! MIRROR
" Remove the SPEAKER GRILLE.
" Remove the FRONT CONTROL BOX.
" Remove the SCREEN ASS'Y.
1. Remove 2 screws I attaching the mirror stopper.
2. Raise slightly to disengage of the mirror from the hooks.
3. Remove the MIRROR.
NOTE :
" The MIRROR is front-coated. Do not touch the front of the
MIRROR.
" At least 2 persons are recommended for removable and
reassemble.
! REAR PANEL
1. Loosen 7 screws J.
2. Remove 4 screws K .
3. Raise slightly REAR PANEL upward.
4. Remove the REAR PANEL.
NOTE :
" Before the rear panel is inserted into the cabinet, release the
short-circuit between the SB connector (1) pin and (2) pin of
the digital input unit
" After releasing the short-circuit between the SB connectors,
do not turn the power on until the rear panel is inserted into
the cabinet
! PARTITION
" Remove the REAR PANEL.
1. Pull out the PARTITION back ward.
! REAR COVER
" Remove the SPEAKER GRILLE.
" Remove the FRONT CONTROL BOX.
" Remove the SCREEN ASS'Y.
1. Remove 2 screws L .
2. Remove 2 screws M from front side
3. Slightly pull for backside to disengage of the REAR COVER from
hooks.
4. Remove the REAR COVER.
12
H
MIRROR
I
MIRROR STOPPER
REAR COVER
PARTITION
J
J
K
J
No. 51914
SCREEN ASS'Y
M
M
BRACKET
L
REAR PANEL
Ｇ Ｇ Ｇ Ｇ
Ｇ Ｇ Ｇ Ｇ
HOOKS
L