Kyocera YASHICA T ZOOM Instruction Manual page 5

Table of Contents

Advertisement

• Do NOT use excessive force on the lens barrel. The camera might be damaged.
• If the camera has been dropped, take it to our service center. There might be damage which is not visible
A
WARNING
• If any defect Is found with the unit while using It (e.g. camera body becomes extremely hot, there is
smoke or smell of the burning, etc.), immediately stop using it. switch off the power, and remove the
batteries. They may cause a fire hazard or burn. (Be careful not to get burned when removing batteries.)
• Do NOT use the unit in a very humid environment, or places where it may get wet. Do NOT operate
it with wet hands. The unit may be damaged by corrosion, fire, smoke, overheating, short circuit, or
electric shock. (Special caution is required when operating in rain, with snow on the ground, at the
beach, and near water.)
• Do NOT use the unit in an environment in which there may be inflammable gas.
• Do NOT disassemble, modify, or reassemble the unit. It may cause electric shocks due to the high
voltage.
• A high-voltage circuit is built into the product; therefore, NEVER touch the internal parts of the unit
when it is damaged due to dropping, etc. There is a risk of causing electric shock (unit with a built-in
flash).
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

Yashica t4 zoom

Table of Contents