Table of Contents
Advertisement
To Use the STOP/CLEAR
Pad
1. Erase if you make a mistake during programming.
2. Cancel minute timer.
3. Stop the oven temporarily during cooking.
To Cancel a Programme During Cooking
If you are in the process of cooking and wish to stop the oven and cancel the entire cooking programme,
follow either of the steps below:
1. Open the oven door.
2. Close the door.
3. Touch the
(STOP/CLEAR) pad.
or
1. Touch the
(STOP/CLEAR) pad twice.
MICROWAVE
COOKING
There are five preset power levels.
Time Cooking
Approximate percentage of microwave
power
for each power
level.
4; FULL POWER (HIGH)
(Touch the [qf] =<] (MICROWAVE) pad once.)
100% (650W)
4
ROAST
(M. HIGH)
(Touch the (qi) =<] (MICROWAVE) pad twice.)
70% (455W)
tts SIMMER (MEDIUM)
(Touch the (af) =<] (MICROWAVE) pad 3 times.)
50% (325W)
vis DEFROST (M. LOW)
(Touch the [df] =<] (MICROWAVE) pad 4 times.)
30% (195W)
<3 WARM
(LOW)
(Touch the [df] =<] (MICROWAVE)
pad 5 times.)
10% ( 65W)
Many foods are cooked at FULL POWER (100%) for best results. The
— [ff]
(MICROWAVE)
pad al-
lows you to select the rate of microwave cooking, but the oven will automatically operate at
4, (FULL
POWER)
if the
(ip)
(MICROWAVE)
pad is not touched.
Your oven can be programmed for up to 4 automatic cooking sequences, switching from one variable power
setting to another automatically.
Suppose you want to heat soup for 2 minutes 30 seconds at
ry
(SIMMER).
1. Enter desired cooking time. (2'30'')
cs
Refer to the attached
2. Touch the
[tp]
(MICROWAVE) pad 3 times.
"'Auto-Touch Sheet"' E.
3. Touch
(MINUTE PLUS/START) pad.
To program a second sequence, for example 1 minute 30 seconds at
ty
(FULL POWER);
3. After Step 2, enter desired time for second cooking sequence. (1'30'')
4. Touch
(MINUTE PLUS/START) pad.
The timer will count down the first sequence and when it reaches zero, the second sequence wil appear
on display and begin to count down. When the timer reaches zero, all indicators will go out and an audible
signal will sound. The time of day will appear on the display.
NOTE: 1. When the door is opened during the cooking process, the cooking time in the readout automati-
cally stops. The cooking time starts to count down
again when the door is closedand the
(MINUTE PLUS/START) pad is touched.
2. If the
(i)
(MICROWAVE) pad is touched after reaching the lowest readout (LOQVV), the
display will return to the starting point (HIGH).
3. If
i
(FULL POWER) is selected as the final sequence, it is not necessary to bias ch the
(ai)
(MICROWAVE) pad.
lf 4
(FULL POWER) is not the final sequence, the
[Ui]
(MICROWAVE)
pad must be
touched.
4. The turntable rotates both clockwise and counterclockwise depending on the position («f motor
when starting the cook cycle.
Advertisement
Table of Contents
