Advertisement
WET OPERATION
6.2.
CARPET & SOFA WASHING (FIG.10)
Choose the corresponding brush for cleaning. Ensure there is enough detergent in the tank for best performance. Remove the dust
bag. Ensure large particles of dust are removed before washing. Press the button of the detergent spray gun to spray detergent.
NOTE: on the first use, hold for 10 seconds to allow the detergent time to pump out. Move the brush evenly and slowly across the
carpet or sofa. Release the button on the backstroke to allow for vacuuming of waste water.
6.3.
FLOOR CLEANING (FIG.11)
Use the wet & dry floor brush for cleaning floor, dust, rubbish, spillage, etc.
FIG.12
6.4.
AIRFLOW ADJUSTMENT (FIG.12)
Press the button on the detergent spray gun to adjust the suction.
6.5.
BLOWING FUNCTION (FIG.13)
Insert the end of the plastic hose into the blower, and twist it clockwise to lock. Switch on the vacuum cleaner to start the blower.
6.6.
FILTER-CLEANING FUNCTION (FIG.14)
If using to clean thick dust, such as that in a garden, workshop or
newly decorated room, the filters will get clogged easily. In this case,
press the filter-cleaning button on the back of the unit several times.
Suction power should improve afterwards.
6.7.
PROTECTIVE DEVICE - WATER VALVE (FIG.15)
The protective valve begins to work when the tank is full of dirty water.
The appliance will make a noise that indicates the motor is running at
a higher speed. When this occurs, turn off the appliance and empty the
water.
7.
MAINTENANCE
FIG.16a
Washing
7.1.
CLEANING (FIG.16A & 16B)
After heavy use, or when the barrel is full of dust and dirty water, please follow the procedure below:
7.1.1. Unfasten the clips and remove the head unit.
7.1.2. Take off the filter bag, pour out and clean up the dust and dirty water in tank, and wipe the tank dry.
7.1.3. Wash and clean the filters, including HEPA filter and sponge filters. Filters should be dried before the next use.
NOTE: Filters should be changed regularly to ensure optimal performance.
7.1.4. Reinstall all the accessories and units as per the assembly instructions above.
7.2.
LUBRICATING OIL (FIG.17)
Moderate lubricating oil should be added to the sealing locks and pipe jacks for smooth operation.
© Jack Sealey Limited
FIG.13
FIG.15
FIG.16b
Drying
Original Language Version
FIG.14
FIG.17
PC310.V2
Issue 1
06/12/23
Advertisement
