Table of Contents
Advertisement
MEASUREMENT SETUP CHECKLIST
Here are the steps to set u p swept sine measurements:
1 . Select swept sine mode: press MEAS MODE followed by SWEPT SINE
(page 3-1)
2. Set up the receiver: select linear or log sweep and set u p auto gain, if necessary,
in the MEAS MODE menu. (page 3-2)
3. Set the frequency span and resolution: use the FREQ menu. (page 3-5)
4. Set up the source: use the SOURCE menu. (page 3-8) To set up source
protection, see page
3-9
5.
Set up averaging and integration: use the AVa menu. (page 3-1 0)
6. Select a display: use the MEAS DISP menu. (page 3-13)
7. View the input signals (if necessary): use the VIEW INPUT menu. (page 3-1 8)
8. Set up the inputs: refer to Chapter 7 for range, calibration, coupling and
engineering units.
9. Start the sweep: press START.
1 0. Select other displays, if desired: use the MEAS DISP menu. (page 3-1 3)
1 1 . Use marker and display features, if desired: refer to Chapter 8 for instructions.
t,;napter :.:s-usmg me tiwept time Moae
MEASUREMENT SETUP CHECKLIST
3·19
Advertisement
Chapters
Table of Contents
