Advertisement
CP-S830W
CP-S830E
2. Adjustment of white balance.
@Preset R751(G BLK) ,R851(R BLK) and R951(B
BLK) to the mechanical center.
@Input 16 steps monochrome green at 0.7Vp-p with
a timing signal of SVGA VESA(60).
@ Adjust R665(W SUB CONTRAST) and R6e6s(W
SUB BRIGHT) so that brightness of 16 steps is
best,....visual check.
@JInput gray pattern at 0.21Vp-p with a timing signal
of SVGA VESA(60).
® Adjust R870(R SUB BRIGHT) and R970(B SUB
BRIGHT) so that the chromaticity at the center of
the picture is x=0.280+0.005,y=0.3600.005
(middle-brightness white balance)
@Input gray pattern at 0.52Vp-p with a timing signal
of SVGA VESA(60).
1-3
Panel phase adjustment
Adjustment procedure
@aAs following procedure, adjust it with each timing
signal ; SVGA VESA(85), MAC16, SVGA VESA
(75), SVGA VESA(56), VGA VESA(60) and XGA
VESA(60).
@ Input cross hatch monochrome
green at 0.7Vp-p
with a timing signal of SVGA VESA(60), and adjust
H.PHASE of menu so that the best at vertical lines.
@ Input character signal monochrome
green at
0.35Vp-p.
(CHARACTER Format:
1 Code:83hex [ EES ]
Font:16*16 Cel:16*16)
1-4
Sensor adjustment
Preparations for adjustment
@ Apply heat-running for 10 minutes or more before
adjustment.
@Adjust R862(R SUB CONTRAST)
and R962(B
SUB CONTRAST)
so that the chromaticity at the
center of the picture is x=0.280+0.005,y=0.360+
0.005 (hi-brightness white balance)
@)Input gray pattern at 0.07Vp-p with a timing signal
of SVGA VESA(60).
@Adjust R851(R BLK) and R951(B BLK) so that the
chromaticity at the center of the picture is
x=0.280-£0.01,y=0.36020.01
(low-brightness
white balance)
(Repeat
@ to © and adjust middle, hi and low-
brightness white balance.
note When majoring and adjustment using Minolta
CL-100.
@Adjust "PANEL PHASE" in "S/H" of adjustment-
menu (*) so that the lest vertical stripe pattern.
Note:Never change "S/H PHASE" of adjustmeni-
menu (*).
-> Fix "0", only XGA VESA(60) fix "1".
* how to set up adjustment-menu
1st Push MENU button, 2nd Push RESET button
and keep 5sec. or more, 3rd Select S/H of head
line.
Adjustment procedure
Adjust RW04 to get following values.
0.018 + 0.002 [V]
(Connect @ side to TWT1
and@ side to TWT2 by
digital meter.)
CP-S830W
YK
No. 0488E-1
Digital Media Systems Division
CP-S830E
QR27682
Printed in Japan (B)
Advertisement
