Table of Contents
Advertisement
The Microwave Oven is supported by a special bracket
assembly (mounting system) supplied with the oven.
The bracket assembly must be mounted to the wall
with toggle bolts through the wall, and a lag screw
into a wall stud. After the bracket assembly is installed,
the unit can be slid over the two rails of the bracket
assembly. Two bolts are run down through the cabinet
bottom and into the oven case to pull the oven up
against the cabinet bottom.
NOTE : For easier removal and personal safety it is
recommended that two people remove this product.
II/
t
/
/
Mounting
Plate
!
PRECAUTION
The mounting surface must be capable of supporting the cabinet load, in addition to the 64 pound
product, plus additional loads of up to 50 pounds or a total weight of 114 pounds. This product cannot
be installed to cabinet arrangements such as an island or peninsula.
It must be mounted to both a top
cabinet and wall.
VENT BLOWER
The vent or exhaust blower is located at the top of the
oven. It is shipped for recirculating exhaust but can be
changed to rear exhaust or vertical (See installation
instrustions on how to change and/or blower section on
how to remove).
REMOVE SCREWS
COOKTOP
LIGHTS
One 20-watt screw base halogen bulb is located on the
bottom. The bulb is user replaceable by removing one
screw and lowering access cover.
OVEN L_GHT
A 40-watt screw base incandescent bulb is located in the
top of the oven cavity at the front.
It is user replaceable by removing the top grill (2 screws.
On the front of outer case.). The bulb is then accessible by
removing a metal cover.
REUSABLE
GREASE
FILTERS
The metal filter trap grease released by foods on the
cooktop. They also prevent flames from foods on the
cooktop from damaging the inside of the microwave.
For this reason, the filter must ALWAYS be in place when
the hood the vent fan is used. The grease filter should be
cleaned once a month, or as needed.
Charcoal
Flte
ReL;sable
Grease
F_lter s
Advertisement
Table of Contents
