Technics SX-PR270 M Service Manual page 11

Phenomenon
Remedy
SEQUENCER
Storage is not possible.
The remaining storage capacity of the SEQUENCER memory
is 0. Use the TRACK CLEAR or SONG CLEAR function to
erase the memory.
e The MIDI EXT. SEQ. MODE is set to on. Set it to off.
Multi-track storage is not possible.
¢ The playback track has been selected, but the START/STOP
button has not been pressed. A flashing track indicator shows
the track which is ready for recording, and a lit track indicator
shows a track which is ready for playback. To record one
track while listening to another (playback) track, press the
START/STOP button to begin playback.
A previously stored song is played back.
eThe tracks of a song which was previously stored have not
been cleared. Use the TRACK CLEAR or SONG CLEAR
function to erase the memory before recording a new song.
a
wi
7
°o
a
=
.°)
is)
| Storage is not possible.
«The remaining storage capacity of the COMPOSER memory
is 0. Erase a COMPOSER number button in the RHYTHM
SELECT section in which a pattern is stored.
The playback timing of the rhythm pattern is
eThe QUANTIZE function was on when the pattern was
¢The time signature cannot be changed for a pattern which is
currently stored in the COMPOSER. Press the COMPOSER
CLEAR button to erase the previously stored rhythm pattern.
When editing a preset rhythm, the drums sound
is not erased even when the PERC ERASE
button is pressed.
e Some of the drums sounds of preset rhythm patterns cannot]:
be erased. Follow the COMPOSER CLEAR procedure.
Digital Disk Recorder
The Digital Disk Recorder produces a noise
during recording or playback.
e This occurs when the Digital Disk Recorder is reaciing a disk.
It does not indicate a problem.
e When performing the load operation from a memory disk, the
SEQUENCER memory changes to that of the data loaded
from the memory disk. If you wish to preserve a somg which is
stored in the SEQUENCER memory, save it in amemory disk
before performing the load procedure.