Table of Contents
Advertisement
1.
Plug your styler into the mains power supply.
2. Press the on (C) button to switch on.
3. When it is ready to use, your styler will beep three times and the display will stop flashing.
StyleAdapt™ Mode
1.
When first switched on your styler will be in StyleAdapt™ mode 1. The StyleAdapt™ indicator
will be fully lit up and StyleAdapt 1 will be shown on the display.
2. Working on one section at a time, run your styler through the entire length of your hair without
stopping.
3. After each pass through your hair, the StyleAdapt™ indicator will spin (fig. A) indicating that
your styler is learning about your hair and adjusting the plate temperature to a heat that is
personalised to you. The temperature changes are not shown on the display but happen quickly
and automatically during styling.
•
If you are sharing your styler select StyleAdapt™ mode 2. This ensures that when the styler is
used by someone else, it doesn't change what it has learned about your hair. To select, press the
K button until StyleAdapt 2 is shown on the display.
Manual Mode
To override the StyleAdapt™ mode and use as a standard styler, press the K button several
1.
times until the display shows the temperture (e.g. 160ºC) and the StyleAdapt™ indicator goes
off. Note that in manual mode, your styler will no longer be learning about your hair and
adapting the heat.
2. Select the appropriate temperature for your hair using the controls on the side of the product.
Start styling on the lower temperatures first.
3. The '+' button will increase the temperature, the '-' button will decrease the temperature.
Recommended Temperatures
Temperature
300°F - 340°F
360°F - 400°F
410°F - 450°F
Caution: the hottest temperatures should only be used by experienced stylers
4. Working on one section at a time, run the straightener through the entire length of the hair
without stopping.
To re-activate StyleAdapt™ mode press the K button until StyleAdapt 1 is shown on the
5.
display and the StyleAdapt™ indicator is illuminated. Your styler will now be learning about your
hair and adapting the heat again.
6. After use, press and hold the off button for two seconds to turn off then unplug the appliance.
Memory Function
•
Each time you use your styler it will automatically set itself to the last setting used.
Hair type
Thin / fine, damaged or bleached hair
Normal, healthy hair
Thick, very curly and difficult to style hair
5
Advertisement
Table of Contents
