Continuous Playback - Teac W-520R Owner's Manual

Playback with TAPE | or TAPE II
1. Check that the TIMER switch is OFF.
TIMER
. Press the POWER switch to ON.
POWER
. Set the REV MODE switch to the required tape
travel mode, referring to the chart "Tape Travel
Depending on Setting of REV MODE Switch" on
page 7.
REC
OFF
PLAY
REV MODE
CONT PLAY
[[—] <> S
. Load a pre-recorded cassette in TAPE | or Il.
. Select the appropriate DOLBY NR system.
DOLBY NR
. Press the <4 or ® button for TAPE | or Il to start
playback.
wc
woe
OFF
. Adjust the volume with the amplifier's volume
control.
To stop playback, press the STOP button.
STOP
Continuous Playback
1. Load pre-recorded cassettes in TAPE | and TAPE
. Set the necessary controls and switches but not
the <4 or & buttons, referring to "Playback with
TAPE | or TAPE II" on the left.
. Set the REV MODE switch to the CONT PLAY
(C=) position.
REV MODE
CONT PLAY
=e Ss
. Press the <4 or ® button of the deck to be
played back first.
Eas
. Tapes will be played back continuously,
according to the chart on page 9.
To stop continuous play before 5 cycles have
been completed, press the STOP button of either
deck.