Advertisement
ATA
AT2*. AT2'
16°
soo
TE
Ga
=a,
MEMORY
MEMORY
|j
| |
2
3
|
Jl
À — J À É Á
PROGRAM
SET
O
[Setting Tones with the Levers]
When
you
select
the COMBI.LEVER
button,
you
can
obtain the tone which
is set by the UPPER
FLUTE and
UPPER
ATTACK
levers on the preset board. Click stops
are provided
for each of these
levers. The
further you
pull them
forward,
the
louder
you
can
set
the vol-
ume. This enables you to finely set the volume for each
of the levers. With these levers it is possible to produce
subtle shades of volume just the way you want.
FLUTE levers: You can create various organ sounds by
combining the optional levers. The numbers
above the
levers indicate the respective sound
intervals, and ten
possibilities are available for the Upper Flute.
(Sound intervals for the levers when middle © is pressed)
Middle C
i
16
8
ATTACK
and ATTACK
LENGTH
levers: Attack tones
are short notes with a rapid rising of sound. When
they
are set together with the Flute tones, a crisp sound can
be produced.
The time length of the Attack tones can be controlled
with the LENGTH
lever.
RESPONSE
TIMBRE
FAST
LI
VARI
L]
(Preset Board)
[Storing the Setting for the Levers in
Memory]
Using the 3 MEMORY
buttons, you can store the tone
which was set with the FLUTE and ATTACK
levers into
memory
before a performance. Then without
having to
Set the levers while performing, you can create the tone
you want with a single touch.
1) Using the levers, set the tone you want stored in
memory.
2) While you are pressing the PROGRAM
SET button
on the
preset
board,
set
1 of the
3 MEMORY
buttons located on the control panel.
When
the indicator
light for the on MEMORY
button
flashes,
it indicates
that the tone
has
been
stored
in
memory.
* Once a tone has been stored
in memory,
it will not
be erased until a new tone is set using the same but-
ton, even if the power is turned off.
@RESPONSE
FAST
When this button is on, the rising and falling sound of
the Combination tone become sharp, and a hard sound
is produced.
@ TIMBRE VARIATION
When this button is on, the Combination tone changes
and a sparkling full sound can be produced. The timbre
of Upper and Lower flute 16'. 8'. 4'. is changed.
Advertisement
