Table of Contents
Advertisement
Trouble shooting
en
Close the appliance door fully.
2.
Slide each panel back in and make sure that it is
3.
sitting correctly at the bottom in the retainer (fig.
Push each panel in at the top (fig.
4.
Put the cover back in place and press on it until you
5.
hear it click into place (fig.
Open the appliance door again fully.
6.
Close the two locking levers on the left and right
7.
(fig.
).
%
Close the appliance door.
8.
Caution!
Do not use the cooking compartment again until the
panels have been correctly fitted.
18
"
).
#
).
$
3Trouble shooting
).
I f a fault occurs, there is often a simple explanation.
T r o u b l e s h o o t i n g
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
Rectifying faults yourself
You can often easily rectify technical faults with the
appliance yourself.
If a dish does not turn out exactly as you wanted, you
can find useful cooking tips and instructions at the end
of this instruction manual. ~ "Tested for you in our
cooking studio" on page 20
Fault
The appliance is
not working.
The time is flash-
ing on the display.
The settings on
the appliance
cannot be config-
ured. A key sym-
bol has lit up on
the display or
†'""
.
--------
:
Warning – Risk of injury!
Incorrect repairs are dangerous. Do not attempt to
repair the appliance yourself. Repairs must only be
carried out by one of our trained after-sales engineers. If
the appliance is defective, call the after-sales service.
:
Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Error messages on the display
If an error message with "
e.g.
-
, touch the
"ܠ
„ƒ
error message. Reset the time, if necessary.
If the fault was a one-off, you can continue to use your
appliance as normal. If the error message appears
again, call our after-sales service and quote the exact
error message and the E no. of your appliance.
~ "Customer service" on page 19
Possible
Notes/remedy
cause
Defective cir-
Check the circuit breaker in the
cuit breaker.
fuse box.
Power failure Check whether the kitchen light
or other kitchen appliances are
working.
Power failure. Reset the time.
The child-
Deactivate the childproof lock by
proof lock is
pressing and holding the button
activated.
with the key symbol for approx. 4
seconds.
" appears on the display,
"
button. This will reset the
v
Advertisement
Table of Contents
