Table of Contents
Advertisement
Play Back your Recordings
TV Playback or Viewing
Your Palmcorder may be connected to a
TV to play back tapes or to view what you
are recording.
TV with AUDIO/VIDEO IN Jacks.
To Audio in | Y
Audio/Video
Cable
(Supplied)
ey
To Audio/Video Out
TV without AUDIO/VIDEO IN Jacks.
To Audio!
Video Out
ps
RF Adaptor
(optional)
VHF Antenna
300 ohm-75 ohm
transformer
(not supplied)
or F Connector
UHF Antenna
Selector
VHF Connecting
Cable
(not supplied)
To VHF Antenna
Terminal
26
Before you begin...
* Connect the Palmcorder to a power source.
1 Set the POWER switch to VCR for
tape playback.
Or, set to CAMERA to view what your
Palmcorder is recording.
2 Turn the TV ON and set it to LINE
INPUT.
Check your TV operating instructions.
Note:
If your TV has no VIDEO or AUDIO IN jacks,
select CH 3 or 4 on your TV to match the
CH 3/4 switch setting on the OPTIONAL
PV-RF16 RF Adaptor. Set the VCR/TV
selector on the AF Adaptor to VCR for
playback.
D suni playback or begin a recording.
If you have connected the
Palmcorder to your TV using the
PV-RF16 RF Adaptor and want to
watch TV only:
Set the POWER switch to OFF on the
Palmcorder.
Then, set the VCR/TV Selector on the
Adaptor to TV.
Now, turn the TV ON and select a
channel.
RF
CATV System Installer
This reminder is provided to call the CATV
system installer's attention to Article 820-40
of the NEC in USA (and to the Canadian
Electrical Code in Canada) that provides
guidelines for proper grounding and, in
particular, specifies that the cable ground
shall be connected to the grounding system
of the building, as close to the point of cable
entry as practical.
Advertisement
Table of Contents
