Setup Instructions; Product Specifications - Intex SX 1500 Owner's Manual

PRODUCT SPECIFICATIONS

The sand filter removes suspended particles but does not sanitize your pool. Pool
chemistry is a specialized area and you should consult your local pool service specialist
for details.
Power:
Wattage:
Maximum working pressure:
Effective filtering area:
Pump flow rate (at pump outlet):
Recommended filtering media:
(Not included)
Recommended filtering media quantity: No. 20 silica sand 12 Kg (26 Lbs) or glass sand
Limited Warranty:
TOOLS REQUIRED: One (1) Phillips screwdriver
Pump location and mounting:
• The system must be installed on a solid level and vibration-free base.
• Provide a location protected from the weather, moisture, flooding and freezing
temperature.
• Provide adequate access, space and lighting for routine maintenance.
• Pump motor requires free circulation of air for cooling. Do not install the pump in a
damp or non-ventilated location.
A team of 2 or more people is recommended for setting up this product.
The appliance is intended only for household use.
Leaf trap setup:
1. Make sure the pump o-ring (6) is in place. In a clockwise motion screw the leaf trap (19)
onto the motor inlet (see drawing 10).
Sand tank installation:
1. Place the tank support base at the selected location.
2. Place the tank on the tank support base (see drawing 11.1).
10
6
19
SAVE THESE INSTRUCTIONS
(341GS) MODEL SF90220RC-2 SAND FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 09/20/2022
220-240 Volt AC
130 W
1.4 bar (20 psi)
0.05 m 2 (0.54 ft
5.7 m 3 /h (1500 GPH)
No. 20 silica sand or glass sand. Particle size
range 0.45 to 0.85 mm (0.018 to 0.033 inches).
Uniformity Coefficient less than 1.75.
8.5 Kg (18.5 Lbs).
see "Limited Warranty"

SETUP INSTRUCTIONS

11.1
2 )
11.2
341
English
GS
11.3
Page 9