Basic Recording - Aiwa Z-L520 Operating Instructions Manual

Up to 30 tracks can be programmed from any of the inserted
discs.
Use the remote control.
7 Press PRGM while pressing SHIFT in stop mode.
"~~ —" and "PRGM" appear on the display.
2 Press one of DISC DIRECT PLAY 1-3 to select a
disc.
Go to the next step when the tray stops rotating.
3 Press numbered buttons 0-9 and +10 to program
a track.
Example:
To select the 25th track, press +10, +10 and 5.
To select the 10th track, press +10 and 0.
Total number of selected tracks
Selected track number
Program number Total playing time of the
selected tracks
4 Repeat steps 2 and 3 to program other tracks.
5 Press P to start play.
To check the program
Each time << or ® is pressed in stop mode, a disc number,
track number, and program number will be displayed.
To clear the program
Press HICLEAR in stop mode.
To add tracks to the program
Repeat steps 2 and 3 in stop mode. The track will be programmed
after the last track.
To change the programmed tracks
Clear the program and repeat all the steps again.
To play the programmed tracks repeatedly
After programming the tracks, press RANDOM/REPEAT
repeatedly while pressing SHIFT until G appears on the display.
OTE
¢ During programmed play, you can not use random play, check
the remaining time or select a track. "Can't USE" is displayed if
you attempt to select a track.
« "FULL" is displayed if you attempt to program more than 30
tracks.
14 ENGLISH
BASIC RECORDING
This section explains how to record from the tuner, CD player, or
external equipment.
TAPE/
DECK 1/2
bm PRESET
il
Preparation ;
« Use Type I (normal) tapes only.
* Set the tape to the point where recording will start.
* Note that recording is done on only one side of the tape.
1 Insert the tape to be recorded on into Deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
"PUSH
EJECT
2 Press one of the function buttons and prepare
the source to be recorded.
To record from a CD, press CD and load the disc(s).
To record from a radio broadcast, press TUNER/BAND and
tune in to a station.
. To record from the connected source, press VIDEO/AUX/
PHONO and play.
3 Press @REC/REC MUTE to start recording. _
When recording from a connected source, start playback of
the source.
inzq
When the selected function is CD, playback and recording
start simultaneously.
To stop recording, press Mf.
To pause recording, press II. (Applicable when the recording
source is TUNER or VIDEO/AUX/PHONO.)
To resume recording, press it again.
Sound adjustment during recording
The output volume and tone of the speakers or headphones are
freely varied without affecting the recording.
« "Can't REC" is displayed if you attempt to record on a tape
with the plastic tabs broken off.
« When recording on tape, close the disc compartment before
starting to record.