Symptoms
Control panel has powered off
due to inactivity.
Washing machine is
unplugged.
Water supply is turned off.
Controls are not set properly.
Door is open.
Circuit breaker/fuse is tripped/
blown.
Washing machine
Control needs to be reset.
will not operate
START/PAUSE was not pressed
after a cycle was set.
Extremely low water pressure.
Washing machine is too cold.
Washing machine is heating
the water or making steam.
Reason
• This is normal. Press the POWER
button to turn the washing machine on.
• Make sure cord is plugged securely into
a working outlet.
• Turn both hot and cold taps fully on.
• Make sure the cycle was set correctly,
close the door and press the START/
PAUSE button.
• Close the door and make sure that
nothing is caught under the door
preventing it from closing completely.
• Check house circuit breakers/fuses.
Replace fuses or reset breaker. The
washing machine should be on a
dedicated branch circuit. The washing
machine will resume the cycle where it
stopped once power is restored.
• Press the POWER button, then reselect
the desired cycle and press the START/
PAUSE button.
• Press the POWER button then reselect
the desired cycle and press the START/
PAUSE button. The washing machine
will shut off if the START/PAUSE button
is not pressed within 60 minutes.
• Check another tap in the house to
make sure that household water
pressure is adequate.
• If the washing machine has been
exposed to temperatures below
freezing for an extended period of time,
allow it to warm up before pressing the
POWER button.
• The washing machine drum may stop
operating temporarily during certain
cycles, while water is safely heated to a
set temperature.
EN
Solution
33