Table of Contents
Advertisement
To adjust the seat
1. Lift the seat up and remove the seat adjustment
knob (A).
2. Loosen the seat adjustment knob (B).
A
3. Move the seat until it is in a position where you
can push the brake and clutch pedals down.
4. Line up the hole in the seat plate for seat
adjustment knob (A) with the hole in the seat.
5. Install and tighten the seat adjustment knob (A).
6. Tighten the seat adjustment knob (B).
To connect the battery
WARNING:
and burn injuries. Do not use metal
wristbands or other metal accessories.
Metal items that touch the battery
terminals can cause burn injuries,
electrical shock, and short circuit of the
battery.
Note:
If it is after the year and month that is written
on the battery label, charge the battery. Charge the
battery for a minimum of 1 hour at 6–10 A.
1. Find the battery location below the seat or the
engine cover.
2. Lift the seat pan or the engine cover to the raised
position.
2301 - 001 - 01.11.2023
B
Risk of electrical shock
3. Remove the 2 terminal caps (A) and discard
them.
4. Connect the red battery cable to the positive (+)
terminal and tighten the bolt and nut as shown.
Move the terminal cover on the terminal.
WARNING:
red battery cable must be connected
to the positive terminal before the
black battery cable is connected
to the negative terminal. This is
to prevent sparks and accidental
grounding.
5. Connect the black cable to the negative (-)
terminal and tighten the bolt and nut fully.
6. Apply petroleum jelly on the battery cables to
prevent corrosion.
7. Lower the seat pan or the engine cover.
To move the product off the skid
1. Lift the cutting deck to its highest position. Use
the lift lever.
2. Push the clutch/brake pedal down to release the
parking brake.
3. Put the freewheel control in the "Transmission
disengaged" position, refer to
storage and disposal on page 34 .
4. Push the product forward off the skid.
5. Remove the strap that holds the deflector
protection up against the product.
To do a check after the assembly
•
Make sure that all assembly instructions are
completed.
•
Make sure that no remaining parts are in the
package.
•
Make sure that the battery is prepared and
charged correctly.
•
Make sure that the bolts for the seat are
tightened and that the seat is adjusted correctly.
•
Make sure that the tires are correctly inflated.
A
Risk of sparks. The
Transportation,
11
Advertisement
Table of Contents
