ST-SV7
TABLE OF CONTENTS
1.
2.
Setting the Time .............................................................. 4
3.
3-2. Cover ............................................................................... 6
3-6. MAIN Board ................................................................... 8
3-7. DSP Board ....................................................................... 8
4.
.............................................................. 9
5.
6.
7.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be dam-
aged by heat.
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED
LINE WITH MARK 0 ON THE SCHEMATIC DIAGRAMS
AND IN THE PARTS LIST ARE CRITICAL TO SAFE
OPERATION. REPLACE THESE COMPONENTS WITH
SONY PARTS WHOSE PART NUMBERS APPEAR AS
SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUB-
LISHED BY SONY.
2
................................................ 2
............................... 28
SECTION 1
SERVICING NOTES
This set is a component of the MHC-SV7AV.
The MHC-SV7AV system configuration is as shown below, and
therefore it does not operate normally unless all four components
are connected.
In performing the repair, connect all components with the system
cables.
Note: The precaution to the users is described on the label stuck
on the back panel (video CD player) and in the troubleshooting
section in the Operation Manual.
System Configuration:
TA
POWER SUPPLY
ST
MASTER & GRAPHIC µ con
DISPLAY
MCE
HTC & VMP µ con
TC
TC µ con
AC IN