Table of Contents
Advertisement
DOOR REVERSIBILITY
Unplug the appliance from the power supply before
carrying out the below-mentioned operations.
Remove the ventilation grill (D).
Unscrew the bottom hinge (E).
Remove the freezer door by releasing it from the
middle hinge (H).
Unscrew the middle hinge.
Remove the fridge door by releasing it from the top
hinge pin (A).
Remove the pin and the washer (A+B) from the top
hinge (C), then mount these on the opposite side,
after having removed the plugs which must be
refitted on the other side.
Refit the fridge door.
Replace the middle hinge to the left hand side.
Replace the freezer door.
Screw down the bottom hinge (E) on the opposite
side by using the screws previously removed.
Remove the plug (F) from the ventilation grill (D)
and replace it on the opposite side.
Re-assemble the ventilation grill (D).
The doors can be aligned by adjusting both the
middle and top hinges.
The middle hinge can be adjusted horizontally, with
the help of a tool, after having slackened the two
screws.
The top hinge is adjusted by slackening the nut with
a 10 mm spanner and then proceeding as shown in
the Figure.
Warning:
After having reversed the opening direction of the doors
check that all the screws are properly tightened and that
the magnetic seal adheres to the cabinet. If the ambient
temperature is cold (i.e. in Winter), the gasket may
not fit perfectly to the cabinet. In that case, wait for
the natural fitting of the gasket or accelerate this
process by heating up the part involved with a
normal hairdrier.
E
F
D
F
D640
D427
D419
H
D405
Fig. 4
F
F
Fig. 4a
C
B
A
Fig. 4b
Fig. 4c
7
Advertisement
Table of Contents
